Here is some pictures of my current commission project I’m doing for a friend. So far assembly took forever since I checked everything with him as far as positioning and posing of each individual model before I glued them together. Unfortunately during assembly I discovered one of the models he gave me to make and paint had only one arm, and then another had no arms at all. The one armed one wasn’t much of a problem as I kitbashed it to give him a bare arm, sculpted some bulk to the shoulder to make it fit, and added a gauntleted hand and it was fixed. Mr. Armless though I will have to wait to finish until I can get the arms for him. So here are the mock up pictures I sent him, and the assembled four Reivers that I have primed and slapped some base coats on.
I have to say, I really hated dealing this this guy… My friend put the parts he wanted on each model on ziplock bags and I then assembled what was in said bags for each unit. Well I quickly discovered that the body that was in the bag was not intended to ever have the arm reaching across to draw the combat knife from the scabbard on it. So I ended up doing quite a bit of altering on this guy to get to a relatively satisfactory result. I realised the left arm was going to have to stick out a fair bit and not set level on the torso, so I shaved the outside of the shoulder down a good bit so when I filled the gap that I knew would be there, the shoulder pad would be in the correct anatomical position and would largely cover the greenstuff contacting the arm to the torso. You can also see below that I pinned the arm as well for extra stability. As for where the scabbard connects to the leg, the angle was all wrong, so I have to shave down the part on the scabbard made to attach onto of the pouches on the leg, and then sculpted a larger pouch to cover this area and blend where I had to cut the edges of the afformention part down. Now here is the kicker that made me feel like a complete idiot after the fact… After browsing pictures of Reivers online to see where the scabbard should attach I noticed that one of the bodies (reiver models have the torsos and legs specific for each one) was actually angled to accommodate the scabbard unlike the body my friend had put in the bag. It was only later that night while laying in bed that a light bulb went of in my head that made me feel (rightfully so) like a complete idiot. My friend just put the parts in each bag without knowing how they would look assembled, so all I would have had to of done was find the body meant to accommodate the scabbard and switch it for use with this guy (the squad leader). Then I could have completely avoided the need to cut, fit and sculpt to make this stupid arm work on body… oh well though hindsight is 20/20 after all.
This guy has an awesome pose, but as far as structural integrity goes, I think Games-workshop really fouled up with him if they expect inexperienced hobbyists to build him. The only point of contact of the model with the base is the tip of his toes as you can see in the picture above. So I decided that rather than make my friends life a nightmare with having to constantly by re-glueing him to his base I would just go ahead and pin him.
I have a ton of work that that still needs to be done on these guys, but all and all I think they are coming along pretty good. I am very pleased with how the bare arm turned out, but I admit I could have taken a little more time on it to fine tune it some more. Bit my friend won’t care he just wants the models done so I don’t have to be quite as fanatically OCD with the modeling as I would for a commission from anyone but a friend lol. But he gave me lax standards and made it clear that he doesn’t want me to take to long with micro details so this won’t be to difficult thankfully haha.